USED OUTBOARD MOTORS


We are factory authorized to service Evinrude, Johnson, Mercury, and Mercruiser engines. Also Ranger, WeldBilt boats, Xpress boats, & Veranda Pontoons. Feel free to give us a call at 217-222-6006 or shoot us an email at aquatech@adams.net

 
Lots of fresh trade in engines and they are ready for the season. 


If factory warranty is no longer valid, all engines come with our "In House" warranty.
Picture Year H.P. Make & Specs Price Comments





 2016  25hp  Evinrude
  ETEC
15" Shaft
Call for
Details
100% Fuel injected, this is a nice engine with only 60 hrs on it, it is set up for tiller handle operation, electric start, and comes with aluminum propeller. Balance of extend warranty valid through 05/04/2022. 






 2014  40hp  Evinrude
  ETEC
  40hp
   Sale Pending  100% Fuel injected. This engine is a Remote steer set up (steering wheel), engine has 42 hrs on it.. Long shaft, electric stat, trim/tilt.  Engine can be converted to tiller handle for additional charge.  This engine is technically a used engine, but as you can tell it was used very little by the amount of hours on it.




  2014  60hp   Evinrude
    ETEC
 20" shaft
 Call for Details 100% Fuel Injected.This is a tiller handle set up, engine has 345 hrs on it.  Long shaft, electric start, trim/tilt.  No propeller Balance of factory extended warranty through 3/18/22.  Engine can be converted to remote steering for additional charge.







 2016  75hp  Evinrude
    ETEC
 20" Shaft
 Call for
 Details
100% fuel injected, this engine is currently set up for tiller handle operation, but can be switched to remote with no problem.  Engine has 235hrs on it (about 78 hrs a year) and has the balance of extended warranty which runs through 04/13/2022.  Long shaft, electic start, trim/tilt, no propeller.
 







 
  2011  150hp   Mercury
     DFI
 Optimax
25" Shaft

Call for Details
This motor is in excellent condition and only has 17 hrs on it, it belonged to an older gentelman.  This engine fits a 25" transom (XL shaft).  Engine comes with wiring harness.  If you are looiking for a new 150hp this is deffinatley one to consider with almost no time on the engine it is well worth the price.  This is a 100% fuel injected 2 cycle engine, so it is good on fuel economy, and clean buring to comply with EPA regulagtions.

This would be a great starter motor for someone or even a great repower option.






  200hp Evinrude
 ETEC
20" shaft
 SOLD 100% Fuel Injected. Remote steering engine (controls not included in price).  Engine had a freshen up in 2016, has a total of 652 hours on engine and 100 hours since freshen up, lower unit had all seals replaced in winter 2018.  This is a one owner and the previous owner was very meticulous.












 2015  300hp  Evinrude
   ETEC
     G2
25" Shaft
Call for Details Engine is ready to hit the water.  This engine fits a 25" transom (XL Shaft).  This is the latest technology in ourboards from Bombardier. This G2 100% Fuel Injected is even better on fuel econmy than its predicessor the ETEC.  Tremendiously increased low end torque than the ETEC as well. Engine is equipped with DPS (Digital Power Steering), built in oil resivoir, and custom side panels. Price does not include rigging components or propeller.
Needing some major Horse Power on your boat, then this is the motor for you. 

Engine has less than 2 hrs of run time, (customer traded to go for dual engine application).  Call for details.
Extended warranty runs through 04/30/2020


If you are in the market for this size engine, this would make a very affordable option for you and get the latest technology in outboard engines.